We are inThree-phase asynchronous motorIn the process of use, how many have encountered the motor burned out, the motor "strike" the entire production will lag behind, so todayMori machineXiaobian and everyone talk about how to avoid motor burning.

       1.Keep the motor clean

       inThree-phase asynchronous motorDuring operation, the air inlet3There is no dust, water and debris in the meter, which is to avoid these being inhaled to cause short circuit medium, or damage the wire insulation, resulting in short circuit between the gate and burn the motor, so we have to ensure the safety of motor operation, in short, to keep the surrounding environment clean, a clean environment is to ensure that the motor in long-term operation to maintain a stable working state of the primary condition.

       2.Operate at rated current

       Many repaired motors are due to overload, excessive drag load, low voltage; Or is driven by the mechanical stuck and so on. If the overload time is too long, the motor absorbs a lot of power in the power grid, the current will increase rapidly, and the temperature will rise, so it is easy to burn. Therefore, in our daily work, we must ensure that the motor works at the rated current, and pay attention to check the operation of the transmission device, the concentricity of the shaft connector and the gear transmission.

       If you want the motor to run stably, it is necessary to do routine maintenance, and then it is too late to repair if there is a problem. aboveThree-phase asynchronous motor manufacturersMori machineSome of the relevant content sorted out, welcome to fill the gaps, if you are interested in this or want to know about our products, you can consult online message or call directly0575-8378-1127.