The maximum torque is an important characteristic of the motor, also known as the stopping torque; That is, under the rated voltage and frequency, the maximum torque generated by the motor when the load is increased but the speed does not suddenly drop. Torque motor manufacturers say that the maximum torque of asynchronous motors is the maximum electromagnetic torque that can be generated by the motor at rated voltage and rated frequency.

YS series three-phase asynchronous motor, is widely used in low-power mechanical transmission equipment, its performance indicators with Y series three-phase asynchronous motor is exactly the same, belongs to the fully enclosed structure motor products, the following and Senli motor small series together with a simple understanding of it!

In the motor selection, how to determine its required power, when we select the torque motor, it is based on the torque required for the production of mechanical locks to select, which must pay attention to the need to keep the motor running under the rated load, the following is a simple understanding with Senli Motor Xiaobian.

In special workplaces, there are long-term low-speed operation and long-term locking requirements, then generally we will choose three-phase torque motor to operate, Seni motor research and development production of this product in the design, taking into account the needs of a variety of uses, in its structure is forced ventilation form to meet the short-term or long-term locking needs.

Torque We often refer to the motor output torque, often N.m (n. Meters) as a unit, when we buy torque motor, we often buy N.m, rather than KW (KW), ordinary three-phase asynchronous motor, kW as a unit to buy. Here is a simple understanding with Senli Motor Xiaobian!

The comparison between the two first needs to have a condition, that is, under certain power conditions, the higher the speed, the lower the torque, such as Senli is the production of 3KW and below small power motor, if you take 1.5KW motor, the 6-level output torque will be higher than the 4-level.

Often start, brake and require rapid braking, accurate positioning of the YEJ electromagnetic brake motor must be no stranger to the occasion, through the three-phase asynchronous motor to install the brake to achieve the braking effect, then you know the ordinary AC motor what are the main braking methods?

The biggest difference between asynchronous motors and synchronous motors is the speed, the asynchronous rotor speed and the stator rotating magnetic field speed is inconsistent, always lower than the stator magnetic field speed, and the synchronous stator winding three-phase current generated by the rotating magnetic field speed, and the rotor magnetic field speed is exactly the same.

The temperature of the normal operation of the torque motor is generally below 40 ° C, and when the temperature exceeds this temperature it is easy to cause the temperature of the motor to rise too fast and too high. If it runs for a long time in such a state, the stator winding and the insulation to the ground are easily damaged and will burn out seriously. The following Senforce motor Xiaobao will take you together for a simple understanding!

The locked-rotor moment is a physical quantity used to measure the ultimate output capacity of a motor. Gridlock means that the torque motor can automatically adjust the speed with the size of the load, when the load increases to a certain extent, the speed will drop sharply, when the load on the shaft makes the motor speed drop to 0, then it is in a state of gridlock, also known as torque gridlock. Here is a simple understanding of Senli motor Xiaobian requirements.